
Furnace maintenance in Aurora, IL
The short answer
Furnace maintenance in Aurora, IL runs $119 for a 60–90 minute tune-up: a 21-point inspection covering the heat exchanger, burner and flame quality, combustion and carbon monoxide testing, and safety controls, with the findings written on the invoice. FortHouse Heating & Cooling charges the same for a rental as for an owner-occupied house, and the draft reading is part of it. About one Aurora home in three is rented, and the City requires landlords to provide heat from September 23 to May 5. Landlords should book in early September; homeowners, any time before the first cold night.
Written by the FortHouse Team. Tune-ups by EPA 608 and NATE-certified technicians.
Should your Aurora furnace be tuned up before September 23?
You rent the home out
The City's heat season starts September 23, and a furnace checked in early September is the simplest way to be ready for it.
It vents into the chimney
Older 80% furnaces often share the chimney with the water heater, and the draft test shows whether it still pulls exhaust up and out.
The house went up before 1980
That's 43.6% of Aurora's housing, and the furnace in it is rarely the first one the house has had.
Two winters have passed since the last service
A coated flame sensor and a dirty filter are behind many first-cold-night lockouts, and the visit takes care of both.
How much does furnace maintenance cost in Aurora?
| Check | On an older furnace | Price | Why it matters in Aurora |
|---|---|---|---|
| Draft at the flue | Whether the chimney pulls exhaust up and out | Included | A chimney that won't draw is a safety finding. You see the reading, and the fix is priced in writing. |
| Vent connector | Rust, gaps, and its pitch up to the chimney | Included | A corroded or loose pipe between furnace and chimney lets exhaust escape into the basement, so it's quoted on the spot. |
| Heat exchanger | Cracks and rust-through | Included | A crack means a new furnace, and Aurora furnace replacement lists the installed prices. |
| Temperature rise | Supply air minus return air, against the label | Included | Shows whether the furnace still delivers its rated heat, the number behind a 68°F apartment. |
| Limit and pressure switches | Each one trips when it should | Included | A switch that won't trip gets replaced before the season; a pressure switch runs $200–$600. |
The $119 covers all 21 points. In an Aurora house built before 1980, the venting checks take longer than on a newer furnace with PVC pipes. The price stays the same, and every reading goes on the dated invoice.
The tune-up found a problem in a rental. Repair it or replace it before September 23?
Use the same two tests as any furnace. Multiply its age by the quote: past $5,000, the money points to replacement. And no single repair should top half the price of a new furnace, which runs $5,000–$9,000 installed in Aurora. For a rental, timing counts too: a replacement scheduled in September beats a no-heat complaint in January.
Repair is likely right when
- It's under about 12 and the heat exchanger passed
- The part is an ignitor, flame sensor or pressure switch
- Draft and CO readings came back normal
Replacement usually wins when
- Draft or CO readings fail on a furnace past 15
- The heat exchanger is cracked
- Tenants already lost heat last winter
| Furnace age | Repair quote | Age × cost | Verdict |
|---|---|---|---|
| 9 years | $300 ignitor | 2,700 | Repair it |
| 14 years | $380 pressure switch | 5,320 | Borderline: price both |
| 22 years | $700 control board | 15,400 | Replace before the season |
How does an Aurora furnace tune-up work, from booking to invoice?
September
Landlords book first
Rental furnaces are best done in early September, ahead of the City's heat season. Homeowners can book any time before the first cold night.
On arrival
Access, then the chimney
The technician confirms who's letting them in, tenant or owner, then looks at the vent connector and chimney before opening the furnace.
Testing
All 21 points
Burner, ignitor, flame sensor, gas pressure, heat exchanger, inducer, limit and pressure switches, blower amp draw, and the temperature rise across the furnace.
Draft and combustion readings
With the furnace firing, the analyzer reads combustion and carbon monoxide, and the draft is measured at the flue.
Afterward
A dated invoice for the owner
The readings, the date and any repair price, in writing. Nothing is repaired without the owner's approval.
What do the vents and readings look like?



What's different about furnace maintenance in Aurora?
One home in three is rented
Of Aurora's 64,331 occupied homes, 35.0% are rented, according to the Census Bureau's 2024 American Community Survey. Under the City of Aurora's rental heating rules, every one of those tenants is entitled to adequate heat from September 23 to May 5. The City sets it at 68°F averaged through the room or apartment, measured at least 3 feet from an outside wall and 3 feet off the floor. That makes early September the sensible time to tune up a rental furnace.
$50–$500 a day in fines
The City says landlords who don't provide adequate heat can be fined $50 to $500 per day. A tenant without heat is told to contact the landlord or the landlord's agent first. If heat still isn't restored, the next call is the City's Customer Service Division at 630-256-4636, or 311; after hours and on weekends, the City's 911 Emergency Center. A furnace checked before the season starts is the cheapest way to stay out of that process.
Older houses, chimney venting
In the same 2024 survey, 83.7% of occupied Aurora homes heated with utility gas and 13.6% with electricity. And 43.6% of the city's housing was built before 1980. Many of those older gas furnaces still vent through a masonry chimney, often shared with the water heater. That's where the tune-up's draft and venting checks earn their place, because a chimney that doesn't draw can push combustion gases back into the basement.
Questions Aurora homeowners ask
How much does furnace maintenance cost in Aurora, IL?
A full furnace tune-up in Aurora runs $119 and is a 21-point inspection, including the heat exchanger, burner and flame quality, combustion and carbon monoxide testing, and safety control verification. FortHouse Heating & Cooling does it in 60–90 minutes, with the draft, combustion and carbon monoxide readings and the safety-switch results written on the invoice. The price is per furnace, the same for a rental as for an owner-occupied house, and a quote well under it usually means the heat exchanger inspection is the step being skipped.
When does Aurora require landlords to provide heat?
From September 23 through May 5, under the City of Aurora's rental heating rules. The City asks for 68°F averaged through the room or apartment, measured at least 3 feet from an outside wall and 3 feet off the floor. Landlords who don't provide adequate heat face fines of $50 to $500 a day, so FortHouse Heating & Cooling suggests finishing rental tune-ups in early September.
My Aurora apartment has no heat. Who do I call?
Your landlord or the landlord's agent first. If heat still isn't restored, the City's Customer Service Division takes the complaint at 630-256-4636, or 311. After hours and on weekends, the City says to call its 911 Emergency Center. FortHouse Heating & Cooling can repair the furnace when the owner books the visit.
Does an older Aurora house change the tune-up?
The 21 points stay the same. On a furnace that vents into a masonry chimney, FortHouse Heating & Cooling spends longer on the draft test and the vent connector. A poorly drafting chimney can spill combustion gases into the basement. That matters in Aurora, where 43.6% of the housing went up before 1980.
Can a landlord keep the tune-up invoice as a record?
Yes. FortHouse Heating & Cooling dates the invoice and writes the combustion, carbon monoxide and safety-switch results on it. That gives a landlord a record that the heating plant was checked before the season. The City's rule requires the heat itself, not a tune-up, so the record is for your files rather than a filing requirement.
What happens if the tune-up finds a problem?
You get the reading and a written price before anything else is touched; the tune-up isn't a sales call. An ignitor runs $200–$400 and a pressure switch $200–$600; a blower motor starts at $450 and a control board at $700, each on top of the $119 visit. Our Aurora furnace repair page covers what those typically run.
When should I schedule furnace maintenance in Aurora?
Now, before the first real cold snap; landlords should finish by early September, before the City's heat season starts on September 23. In a city Aurora's size, the first cold night turns into a week of no-heat calls, and a problem found in an early-fall tune-up is a scheduled repair instead of an emergency. Why the fall window matters goes deeper on the timing.
Do you offer other furnace service in Aurora?
Yes. The same crew handles furnace repair, full replacement, and after-hours no-heat calls across Aurora's East and West Sides, so the fall tune-up and a January breakdown are handled by people who've already seen your furnace.
Sources
The $119 price, the 21-point checklist and the repair prices are FortHouse's published figures. Tenure, heating-fuel and housing-age shares come from the Census Bureau's 2024 American Community Survey; the heat season, the 68°F standard, the fines and the contact steps from the City of Aurora's rental heating requirements.
- Census Reporter — Aurora, IL profile (2024 American Community Survey)
- City of Aurora — Rental Property Heating Requirements (Property Standards)
- EPA — carbon monoxide's impact on indoor air quality
