
Furnace repair in Aurora, IL
Answered 24 hours. Night and weekend fees are quoted before anyone heads out.
The short answer
Furnace repair in Aurora, IL from FortHouse Heating & Cooling starts with a $119 diagnostic during regular hours. Most repairs then cost $150–$600, written down with the failed part named before any work begins. A furnace that runs its blower but never heats usually has a failed ignitor, a $200–$400 fix that's stocked on every truck, so most Aurora calls end with heat on the first visit. The phone is answered 24 hours a day; after-hours visits add a fee we quote on the call. If one repair would cost more than half of a new furnace, replacing it is the better spend.
Written by the FortHouse Team. Serviced by EPA 608 and NATE-certified technicians.
No heat in Aurora: what should you do first?
Get out first
A carbon monoxide alarm or a gas smell comes before any furnace question. Get everyone outside. Call 911 for a CO alarm, or Nicor Gas at 888-642-6748 for a gas smell, from outside the house. Call FortHouse Heating & Cooling after the house is cleared.
Call now, any hour
Call FortHouse Heating & Cooling now, day or night, if the furnace is dead in freezing weather, the house keeps getting colder, or someone at home can't handle the cold. We answer 24 hours a day and quote the after-hours fee before anyone drives out.
Book a daytime visit
Book a regular-hours visit if the furnace still makes some heat but cycles on and off, blows lukewarm air, or has started a new noise. You pay the $119 diagnostic without an after-hours fee, and most repairs are finished that visit.
Check these first
Thermostat on Heat with fresh batteries, the furnace's power switch, the breaker, and the filter. On a high-efficiency furnace, also check that the white plastic pipes outside aren't buried in snow or iced over after a storm.
Price a replacement instead
Ask for a free replacement estimate if the furnace is past 15 years, the heat exchanger is cracked, or the repair would cost more than half of a new furnace. Replacement runs $5,000–$9,000 installed, usually in a day. See furnace replacement in Aurora.
What does furnace repair cost in Aurora?
| What the furnace does | Usual cause | Price | What we do about it |
|---|---|---|---|
| No heat, blower runs | Failed ignitor | $200–$400 | The most common no-start. We confirm the ignitor has failed with a meter before replacing it. |
| Lights, then quits | Dirty flame sensor | $119–$220 | Carbon on the sensor makes the furnace think the flame never lit. On a repair call, cleaning adds $119 and a new sensor $150–$220; a tune-up includes the cleaning. |
| Blower hums, won't spin | Blower capacitor | $200–$400 | The capacitor gives the blower motor its starting kick. A weak one is a quick, common fix. |
| Clicks or error code | Pressure switch or blocked vent | $200–$600 | We check the vent pipes and the condensate drain the switch monitors before blaming the switch itself. |
| Ignitor glows, no flame | Gas valve | $200–$800 | If the gas supply is on and the valve won't open when the furnace calls for heat, the valve is replaced. |
| Loud at startup | Inducer motor | From $600 | The motor that clears the furnace before each ignition. A failing one usually gets loud before it quits. |
| Burners light, no air | Blower motor | From $450 | The motor that pushes heated air through the ducts. The written quote depends on the motor type. |
| Soot, yellow flame, CO alarm | Cracked heat exchanger | Usually replace | Confirmed with a CO reading at the furnace. On most furnaces, a crack is the point where replacement wins. |
Repair prices are on top of the $119 regular-hours diagnostic; nights and weekends add a fee we quote on the phone. Most repairs run $150–$600, and the most common fix, a failed ignitor, is $200–$400. Motors and control boards cost more. Every repair is priced in writing, with the failed part named, before any work starts.
Is your Aurora furnace worth repairing?
Two quick tests. First, the furnace's age times the repair price: past $5,000, replacement usually wins. Second, any single repair that costs more than half of a new furnace means replace. ENERGY STAR suggests weighing replacement once a furnace passes 15 years, and a cracked heat exchanger tips the decision to replacement even when the math is close.
Repair is likely right when
- The furnace is under 15 years old and the repair falls in the usual $150–$600.
- It's the first breakdown this winter.
- The fault is one of the four parts on the truck: ignitor, flame sensor, pressure switch, or inducer motor.
Replacement usually wins when
- The repair is more than half the cost of a new furnace ($5,000–$9,000 installed).
- The heat exchanger is cracked, or the CO reading at the furnace is off.
- It's past 15 years old and this is the second expensive repair in two winters.
| Furnace age | Repair quote | Age × cost | Verdict |
|---|---|---|---|
| 6 years | $300 ignitor | 1,800 | Repair |
| 11 years | $450 pressure switch | 4,950 | Repair, but get a replacement price too |
| 16 years | $700 inducer motor | 11,200 | Replace |

What happens when we come out to an Aurora furnace?
On the phone
Tell us what it's doing
Describe the symptoms and the furnace's age if you know it. We'll say on the call whether it sounds like a part or a replacement conversation, and quote the after-hours fee up front for a night or weekend visit.
At the furnace
Test before touching
Ignition, the flame sensor, gas pressure, and a carbon monoxide reading at the furnace, plus a heat exchanger inspection. Every visit, not as an add-on.
The price on paper
The failed part and the repair price, written down. Nothing gets replaced until you say yes.
Fixed from the truck
Ignitors, flame sensors, pressure switches, and inducer motors are stocked on every truck, so most Aurora calls end with heat on the first visit.
After
Before-and-after readings
The readings taken after the repair go on the invoice next to the first set, so the fix is on paper, not just our word.
What's different about furnace repair in Aurora?
Two sides, four counties
The Fox River splits Aurora into an East Side and a West Side, and the city reaches into four counties: Kane, DuPage, Will, and Kendall. None of that changes a repair call. A house near downtown and one out by Route 59 get the same $119 diagnostic, the same written price, and the same crew.
Nicor Gas territory
Aurora's natural gas comes from Nicor Gas, which keeps a regional office in the city. If you smell gas, leave the house and call Nicor's 24-hour line at 888-642-6748 from outside. A furnace repair waits until the utility says the house is safe, and we'd rather you call them first.
Illinois CO alarm law
Illinois' Carbon Monoxide Alarm Detector Act requires a working CO alarm within 15 feet of every room used for sleeping, and the law covers any home with a gas furnace. If an alarm is chirping, missing, or past its replacement date, mention it on the call. Every repair visit already includes a CO reading at the furnace itself.
Questions Aurora homeowners ask
How much does furnace repair cost in Aurora, IL?
Start with the $119 regular-hours diagnostic. Most repairs then run $150–$600 on top of it. The most common fix, a failed ignitor, is $200–$400; a new flame sensor is $150–$220, and a blower capacitor $200–$400. Motors and control boards cost more. FortHouse Heating & Cooling writes the price down before touching anything. If the problem is a cracked heat exchanger, a new furnace ($5,000–$9,000 installed) is usually the better spend.
Does furnace repair cost more on one side of Aurora?
No. Both sides of the Fox River, and all four counties Aurora reaches into, get the same $119 diagnostic, the same written pricing, and the same crew. Location only matters if the furnace is replaced: inside city limits the permit goes through the City of Aurora, and unincorporated addresses go through their county.
Do I need a carbon monoxide alarm with a gas furnace in Illinois?
Yes. Illinois law requires a working CO alarm within 15 feet of every room used for sleeping in homes with fuel-burning heat, which includes a gas furnace. If an alarm sounds, get everyone outside and call 911 before you call anyone else. Read the Illinois statute.
What should I check before calling about a furnace that won't start?
Make sure the thermostat is on Heat, set above room temperature, and has fresh batteries. Check the furnace's power switch (it looks like a light switch on or near the unit), the breaker, and the filter. On a high-efficiency furnace, check that the white plastic pipes outside aren't packed with snow or ice. If all of that checks out, book the diagnostic. More causes of a furnace that won't turn on.
Is FortHouse Heating & Cooling based in Aurora?
No. FortHouse Heating & Cooling is family-owned and based in nearby Plainfield, and Aurora is one of the main cities we serve. More about who we are.
Sources
Prices are FortHouse Heating & Cooling's own: the $119 regular-hours diagnostic, the $150–$600 range most repairs fall in, and the installed replacement range. Every repair is priced in writing after the diagnosis and before any work starts.
