
Furnace repair in Wheaton, IL
Answered 24 hours. Night and weekend fees are quoted before anyone heads out.
The short answer
Wheaton furnace repair from FortHouse Heating & Cooling costs $119 for the diagnostic in regular hours, then the part: $150–$600 for most repairs, and $200–$400 for an ignitor, the one that fails most. Most Wheaton houses were built before 1980, so the first thing we look at is how yours vents: up a masonry chimney with a metal flue, or out the wall through two plastic pipes. That decides which failures are likely and what the carbon monoxide reading has to clear. You see the part and its price on paper before anything is replaced.
Written by the FortHouse Team. Repairs by EPA 608 and NATE-certified technicians.
Wheaton furnace quit: what should you look at before calling?
CO alarm, gas odor, or soot at the furnace
Everyone out. From outside, 911 for the alarm or Nicor Gas at 888-642-6748 for gas. We come once they've cleared the house.
Lights out on the street
A ComEd outage stops a gas furnace too. Wait for the power, then check the furnace switch (often a red plate) and its breaker.
Metal pipe into the chimney
An older, standard-efficiency furnace. If it keeps shutting off and needing a reset, leave it off: that can be a blocked chimney.
Two white plastic pipes
A high-efficiency furnace. Check outside that snow or leaves aren't covering the pipe ends, and look for water at the furnace's base.
Some heat, nobody at risk
Book a regular-hours visit: the $119 diagnostic plus the part, no night fee, and most fixes done that visit.
What does a Wheaton furnace repair cost, and does it depend on how the furnace vents?
| Part at fault | What you see | Price | Chimney vent or plastic pipe? |
|---|---|---|---|
| Ignitor | Burners never catch | $200–$400 | Both |
| Flame sensor | Flame for a few seconds, then out | $119–$220 | Both |
| Rollout or limit switch | Shuts off, needs a reset | Quoted at the visit | Mostly chimney-vented; find the cause first |
| Blocked chimney or flue | Exhaust smell, CO alarm | Quoted at the visit | Chimney-vented |
| Pressure switch | Clicking, a blinking code | $200–$600 | Both; on plastic pipe, check for snow first |
| Condensate trap | Water at the base, no heat | Quoted at the visit | Plastic pipe only |
| Gas valve | Ignitor glows, no gas lights | $200–$800 | Both |
| Blower capacitor or motor | Hum, but no air from the vents | From $200 | Both; capacitor $200–$400, motor from $450 |
| Heat exchanger | Soot, a lazy yellow flame | Usually replace | Both |
The $119 diagnostic covers a regular-hours visit, and every price above comes on top of it; at night or on a weekend there's an extra fee, which you hear before we head out. Most Wheaton repairs total $150–$600. Inducer motors begin at $600 and control boards at $700. The part and its price go on paper before any work.
A furnace in a 1970s Wheaton house: worth fixing?
With a median build year of 1976, plenty of Wheaton houses are on their second or third furnace, so the question is how old the current one is. Multiply its age by the quote: past $5,000, a new Wheaton furnace at $5,000–$9,000 installed is usually the better buy, and past 15 years ENERGY STAR suggests at least pricing one. A chimney-vented furnace that's failing a CO check rarely deserves another repair. More of that math is in our guide to furnace repair.
Repair is likely right when
- The flue drafts properly and the CO reading is clean
- It's an ignitor, sensor, switch, or capacitor
- The furnace is a newer high-efficiency model
Replacement usually wins when
- A rollout switch keeps tripping on an old chimney-vented furnace
- The heat exchanger is cracked or CO shows at the flue
- It's past 20 and the quote is for a valve, motor, or board
| Furnace age | Repair quote | Age × cost | Verdict |
|---|---|---|---|
| 10 years | $200 flame sensor | 2,000 | Repair |
| 17 years | $275 ignitor | 4,675 | Repair, near the line |
| 24 years | $500 gas valve | 12,000 | Replace |
| 28 years | $600 inducer motor | 16,800 | Replace |

What does a Wheaton furnace repair visit look like?
On the phone
Chimney or pipes?
Tell us how the furnace vents, roughly how old it is, and what it's doing. That shapes what we bring and how urgent it is.
Before the trip
When, and the fee
You get an arrival window, plus the extra fee for a night or weekend. If it can wait for regular hours, we'll suggest that.
At the furnace
Draft and CO first
A CO reading at the flue and a look at the heat exchanger come first, plus the flue itself on a chimney-vented furnace.
Your call
Part and price, in writing
The quote names the failed part and the price. Nothing is touched until you say go.
Wrapping up
Readings, before and after
We run a full heating cycle and record the CO and temperature readings on your invoice beside the first ones.
Older houses, two utilities, one permit: what shapes a Wheaton repair?
Six homes in ten predate 1980
Wheaton's housing is mostly pre-1980: in the Census Bureau's 2020–2024 survey, 12,650 of its 20,359 homes (62.1%) were built before 1980, the median year is 1976, and the 1970s alone produced 5,765 of them. In houses that age, the furnace either still sends its exhaust up the chimney through a metal flue, or it has been swapped for a high-efficiency model with plastic pipes, and each kind fails in its own ways.
Nicor gas, ComEd power
Wheaton's gas comes from Nicor Gas and its power from ComEd, and a gas furnace needs both. Its ignitor, inducer, control board, and blower are electric, so a ComEd outage stops the furnace even with gas at the meter. If your block is dark, wait for the power; if only the furnace is dead, check the switch beside it and its breaker.
Permit and alarms on replacement
Replacing a furnace inside Wheaton city limits takes a permit from the City of Wheaton's Building Division, and the city's residential furnace guideline applies the 2024 International Residential Code: working smoke alarms and carbon monoxide alarms outside each sleeping area. When a repair diagnosis turns into a replacement, budget for alarms if the house lacks them.
Questions Wheaton homeowners ask
What does furnace repair cost in Wheaton?
The regular-hours diagnostic is $119, and most Wheaton repairs then add $150–$600. Ignitors and blower capacitors are $200–$400 each, pressure switches $200–$600, and gas valves $200–$800; a flame sensor is cleaned for $119 or replaced for $150–$220. Blower motors start at $450, inducers at $600, control boards at $700. FortHouse Heating & Cooling quotes it in writing first.
Does my furnace vent through the chimney or through plastic pipes?
Look at the top of the furnace. A metal pipe rising into a brick chimney, often shared with the water heater, means a standard-efficiency furnace, around 80%. Two white plastic pipes running out through a wall or the roof mean a high-efficiency furnace of 90% or more, which also drains water through a small plastic trap. Tell us which you have when you call.
My older furnace keeps shutting off and needs a reset. Is that safe?
Don't keep resetting it. On a chimney-vented furnace, a safety switch near the burners trips when flame or hot exhaust spills out instead of going up the flue, which can mean a blocked chimney or a cracked heat exchanger, and both can put carbon monoxide in the house. Leave it off and book a visit; if a CO alarm sounds, get out and call 911.
Why is my furnace dead when the power is out?
Because nothing in a modern gas furnace starts without electricity: the inducer, the ignitor, the control board, and the blower all need ComEd's power, even though Nicor's gas is still at the meter. When the lights come back and the furnace doesn't, check its switch and breaker before you book.
If the Wheaton furnace has to be replaced, is there a permit?
Inside city limits, yes, from the City of Wheaton's Building Division, and the permitted work has to meet the current smoke and carbon monoxide alarm rules. FortHouse Heating & Cooling files it as part of a Wheaton furnace replacement. Addresses outside city limits with a Wheaton mailing address go through DuPage County.
Sources
Repair and replacement prices are FortHouse Heating & Cooling's own, with the $119 diagnostic during regular hours. Wheaton's year-built figures come from the Census Bureau's 2020–2024 American Community Survey; the permit and alarm requirement from the City of Wheaton's residential furnace guideline.
- Census Reporter — Wheaton city profile, 2020–2024 American Community Survey
- City of Wheaton Building Division — Furnace & Air Conditioner (Residential) permit guideline
- City of Wheaton — Utilities (Nicor Gas and ComEd service)
- Nicor Gas — emergency information and the 24-hour gas leak line
- ENERGY STAR — when to replace heating and cooling equipment
Book your Wheaton furnace repair visit
After hours? Call (630) 318-6246, answered 24/7.
